Welder

• This position will work within teams to weld aluminum and steel enclosed and aluminum open trailer frames
• Following health and safety rules, wear personal protective equipment
• Read and correctly interpret work orders
• Proper operation of welding machines, grinders, torches, tape measures, squares, cranes and miter/chop saws
• Proficiency at reading and executing BOM's and blueprints
• Demonstrate understanding and application of weld types (ex: Fillet, Seam, Spot, etc.)
• Demonstrate understanding and application of joint types (ex: Butt, Corner, Edge, Lap, Tee)
• Demonstrate understanding and application of weld pass positions (Push/Pull, Uphill/Downhill, etc)
• MIG Weld aluminum
• MIG Weld steel
• TIG Weld aluminum
• Demonstrate understanding and proper use of framing jigs for models and layouts
• Demonstrate ability to perform within multiple workstations (Frame Table, Walls, Roof, Fab)
• Ensure correct axle placement and squareness
• Measure, square, and plumb linears prior to final weld placements
• Ensure ramp doors/gates are installed plumb and square and function properly
• Grind any raised welds in areas that will be covered by another flush mount material later (Skins, Roofing, Wood)
• Inspect work for completion prior to releasing to next cell
• Store tools and materials in proper locations when not in use

Maintain clean shop floor between units and at the end of shift

• Use various power and hand tools, experience preferred
• Read and use a tape measure
• Willingness to cross-train between departments
• Read and follow work instructions
• Able to work 40 - 50 hours a week
• Good attendance is required

Physical Requirements:

• Prolonged periods standing, reaching, bending, kneeling, and twisting
• Must be able to move up to 75 pounds at times

PI94bdfb9233ce-1570